I like the look of the earlier FJ60s without the headlight washers (and I don't really need them), so I removed them. The three holes on each side that are left behind didn't look great so I made some plate to cover them up. These can be 3D printed and the files are HERE. I'd much rather have nothing there, but I think this is better than the holes.
I will probably eventually finish and paint them, but the photos are just raw 3D prints. I just used a little double-sided tape to hold them in place.
Sharing files and info just in case someone is in the same spot!
I will probably eventually finish and paint them, but the photos are just raw 3D prints. I just used a little double-sided tape to hold them in place.
Sharing files and info just in case someone is in the same spot!