Harmonic balancer small bolt hole thread size? (1 Viewer)

[RWD]

To be clear, I am NOT talking about the large crankshaft bolt in the center of the balancer. I believe there are two bolt holes that are threaded and can be used to hold a tool that I want to fab up to tighten/loosen the crank bolt. I want to change the crank seal and I'm trying to get some bolts ahead of time before I tear into this project.
Thanks guys

 

[Kernal]

M8 x 1.25. Search is your friend

post #10, 11, 15,

Crankshaft Pulley, Bolt Size (not the 30mm center)?

I sifted through a bunch of threads to try and find the answer which may be at someones finger tips so I'll take a chance asking. The crankshaft pulley (harmonic balancer) on the FZJ80 has two threaded holes that can be used to attach either the SST that one can use to hold the pulley to...

forum.ih8mud.com

 

[RWD]

M8 x 1.25. Search is your friend

post #10, 11, 15,

Crankshaft Pulley, Bolt Size (not the 30mm center)?

I sifted through a bunch of threads to try and find the answer which may be at someones finger tips so I'll take a chance asking. The crankshaft pulley (harmonic balancer) on the FZJ80 has two threaded holes that can be used to attach either the SST that one can use to hold the pulley to...

forum.ih8mud.com

Thanks. I searched harmonic balance pulley instead and couldn't find anything.

 

[flintknapper]

To be clear, I am NOT talking about the large crankshaft bolt in the center of the balancer. I believe there are two bolt holes that are threaded and can be used to hold a tool that I want to fab up to tighten/loosen the crank bolt. I want to change the crank seal and I'm trying to get some bolts ahead of time before I tear into this project.
Thanks guys

Snug them down good. That bolt is on there tight.