I have spent alot of time today putting my hardtop together.
I started by fitting the hardtop sides and then installing garage door weather stripping. I used a sodering iron to bore out the holes so they were perfect to mate the fiberglass hardtop to the sides. I got this idea on MUD and it worked very well.
After I got the top all screwed together I installed the top onto the truck and it fits very nicely except that the b pillar hole won't take the pipe that attached to the hard top. The passenger side needed a little man handling to get it in when the fiberglass hardtop was on but now the darn thing just won't budge on either side.
Need help. I'm sure someone has had this same problem before. I would rather not cut two inches off the bottom but that is something I may have to do.
Any ideas?
I started by fitting the hardtop sides and then installing garage door weather stripping. I used a sodering iron to bore out the holes so they were perfect to mate the fiberglass hardtop to the sides. I got this idea on MUD and it worked very well.
After I got the top all screwed together I installed the top onto the truck and it fits very nicely except that the b pillar hole won't take the pipe that attached to the hard top. The passenger side needed a little man handling to get it in when the fiberglass hardtop was on but now the darn thing just won't budge on either side.
Need help. I'm sure someone has had this same problem before. I would rather not cut two inches off the bottom but that is something I may have to do.
Any ideas?