- Joined
- Feb 26, 2003
- Threads
- 195
- Messages
- 1,782
- Location
- Sherwood Park, Alberta
- Website
- fawcusfitness.com
So I am rebuilding an H55F for someone. This thing was previously rebuilt poorly.
Anyways. I just installed the toyota needle Toyota need roller bearings in the input shaft and the ID is about 26mm. The output shaft bearing surface is 32mm.
What the heck!?
What am I missing here?
Did someone install a different input shaft you think?
Anyways. I just installed the toyota needle Toyota need roller bearings in the input shaft and the ID is about 26mm. The output shaft bearing surface is 32mm.
What the heck!?
What am I missing here?
Did someone install a different input shaft you think?