For Sale Glovebox/Glove Box Handles - Reproduction (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Good morning - do you still have any of these left?
 
Great! PM sent.
 
Check this out! Our friend @flagstaff made an aluminum glovebox handle:

IMG_1482(1).JPG
 
The entire time I have been selling these replacement handles, I have never been asked about the fasteners. And then, the last 2 orders I shipped both asked about the fasteners - go figure!

My old handle had Phillips screws w/ washers. They looked original - who knows?!?

These are ~13/16" for the threaded portion. They are ~1/8" thick at the high point of the threads (yes, they size the fasteners at the bottom of the threads).

I hope this helps.

IMG_1561(1).JPG

IMG_1566(1).JPG

IMG_1562(1).JPG

IMG_1564(1).JPG
 
I really like my glove box handle that I ordered from you. Especially since I had to forego the original cover and make an aluminum one so that it was thin enough to open above the Vintage Air. So now at least my handle looks original. LOL. Never thought about the screws…just pulled a few from the bin and screwed it right on.
 

Users who are viewing this thread

Back
Top Bottom