So my rear passenger side window hasn't worked for a while.
I ordered a new regulator just to find out that the old one wasn't broke, it was just that the glass run was so gunky the window was pretty much seized in there.
I ended up taking apart the door panel, removing the glass run and taking out the division bar to remove the window.
The door glass was filthy, so I removed the glass channel fillar\glass channel and gave it a good clean.
I did the same thing with the glass run.
So i put everything back together...
by the way, is there an "method" to get the fillar and channel back onto the glass...what a pain in the ass
Now here's the problem...the window rolls up slow as mess....and when i try to roll it down the channel\fillar pops off the window, so I can't roll it back up or do anything really...
any solutions?
I ave the FSM and whoever wrote this deff never had to install the channel\fillar onto the glass, cause it tells you to just tap it with a hammer....
I ordered a new regulator just to find out that the old one wasn't broke, it was just that the glass run was so gunky the window was pretty much seized in there.
I ended up taking apart the door panel, removing the glass run and taking out the division bar to remove the window.
The door glass was filthy, so I removed the glass channel fillar\glass channel and gave it a good clean.
I did the same thing with the glass run.
So i put everything back together...
by the way, is there an "method" to get the fillar and channel back onto the glass...what a pain in the ass
Now here's the problem...the window rolls up slow as mess....and when i try to roll it down the channel\fillar pops off the window, so I can't roll it back up or do anything really...
any solutions?
I ave the FSM and whoever wrote this deff never had to install the channel\fillar onto the glass, cause it tells you to just tap it with a hammer....