gappin plugs (1 Viewer)

[Varty Yo]

so what should my plugs be gapped at.............67 with a f motor, im runnin champions are they the best ones to run?

 

[brian]

depends what kind of ignition stuff you have.
i'm running mine at 0.065", but i have some other "stuff".

 

[IDave]

60s F manual sez .8 - .9mm or .031 - .035 inches.

 

[cruiser_007]

I just installed new Denso plugs from CCOT on my '68 (F engine) and they said to gap them at 0.032.

 

[Poser]

That is what I gap plugs running normal ignition at, .032.


Good luck!


-Steve

 

[DocB]

The best ones are Denso or I use NGK, bpr5ey I think.

 

[ken_79-fj40]

.032 on ngk bpr5ey's . I put bosch w8dc's in it last week and it ran terrible until I finally figured out it was the plugs and not the points and condensor I changed at the same time.

 

[e rock]

I think I've got NGK's in there now (64 F) and with an Accel Super Coil, I've got them out to .040 and haven't noticed any problems but it does seem to start a bit easier.

If I had the time, I would like to do some experimenting to see how big I can go with that coil. I suspect I would be ok to at least .045 or .050".

 

[red dirt squirt]

i'm using NGK at .032 all stock under the hood.

 

[IDave]

NGKs here, too. Both my trucks came with others (AC, Champion) and definitely run better with NGKs.

 

[xjnation]

The Toyota factory F engine repair manual says .7-.8mm (.028-.031")