I am planning a 3000 mile broverlanding/wheeling round trip trip out west in October, and I'm working through a complete baselining on my '94 with 235K. A lot of what I've done so far is peace of mind stuff since I have no idea what the POs did or didn't do. Next on my list is fuel pump replacement, and I'm checking to see if this list covers everything I need:
23217-16490
77169-60010
23219-03010
90430-12026 (x2)
23221-66040
Do I need to replace EFI relay while I'm at it? Part number?
I think I've got the bulk of the rest covered, but here is the list of what I've replaced up to now to get her ready for the next 100k. This list is all new, all OEM, except for TREs. If I'm missing anything, or if anyone has thoughts on additional stuffs, love to hear from the pros here.
Dist O ring
Fuse Link
Fan Clutch
Speedo Assembly O ring
Belts
All Rad Hoses
Plugs
Plug Wires
Dist Cap
Dist Rotor
PCV Valve and hoses
Valve Cover Gasket
Cleaned throttle body and new gasket
Tube Seals
Spark Plugs
Heater Valve (plastic was yellowing...matter of time)
Fuel Filter
Oil Pump Cover Gasket
Front Crankshaft Seal
Rear Main Seal
All small coolant hoses
PHH
Water Pump
Complete Birf Rebuild (new wheel bearings incl.)
Tie Rod Ends
Rebuilt front calipers (new pistons incl)
I've also:
Rear heater bypass
eliminated LPSV
disabled EGR
PAIR removal
Still to do:
Starter (rebuild or replace)
Alt (rebuild or replace)
All fluids, tranny drain and fill
Thermostat
Rear wheel bearings (replace or service)
U joints
Am I missing anything? It's nice to have zero leaks, and it's only taken me 3 years to get here!
Thanks Gents!
23217-16490
77169-60010
23219-03010
90430-12026 (x2)
23221-66040
Do I need to replace EFI relay while I'm at it? Part number?
I think I've got the bulk of the rest covered, but here is the list of what I've replaced up to now to get her ready for the next 100k. This list is all new, all OEM, except for TREs. If I'm missing anything, or if anyone has thoughts on additional stuffs, love to hear from the pros here.
Dist O ring
Fuse Link
Fan Clutch
Speedo Assembly O ring
Belts
All Rad Hoses
Plugs
Plug Wires
Dist Cap
Dist Rotor
PCV Valve and hoses
Valve Cover Gasket
Cleaned throttle body and new gasket
Tube Seals
Spark Plugs
Heater Valve (plastic was yellowing...matter of time)
Fuel Filter
Oil Pump Cover Gasket
Front Crankshaft Seal
Rear Main Seal
All small coolant hoses
PHH
Water Pump
Complete Birf Rebuild (new wheel bearings incl.)
Tie Rod Ends
Rebuilt front calipers (new pistons incl)
I've also:
Rear heater bypass
eliminated LPSV
disabled EGR
PAIR removal
Still to do:
Starter (rebuild or replace)
Alt (rebuild or replace)
All fluids, tranny drain and fill
Thermostat
Rear wheel bearings (replace or service)
U joints
Am I missing anything? It's nice to have zero leaks, and it's only taken me 3 years to get here!
Thanks Gents!