- Joined
- Oct 1, 2002
- Threads
- 55
- Messages
- 259
- Location
- Peachland, BC, Canada
- Website
- members.sounddomain.com
Where the fuel line exits the fuel pump on it's way to the carb, I'm having a leakage problem. It's not the actual line that's the problem, but the little "L" fitting that screws into the side of the pump.
When it's as tight as I can get it, it's pointing at the block rather than up where I need it to. If I were to eventually replace the pump, would it come w/ a new fitting or...??
Also, my fuel lines (same ones) are starting to look in rough shape. I don't have the necessary tools/knowledge to bend my own out of hard line, can I use flex line? Would it be dangerous to leave it draped over the valve cover or in front of the cover? (b/c of heat off of it??)
Thanks
When it's as tight as I can get it, it's pointing at the block rather than up where I need it to. If I were to eventually replace the pump, would it come w/ a new fitting or...??
Also, my fuel lines (same ones) are starting to look in rough shape. I don't have the necessary tools/knowledge to bend my own out of hard line, can I use flex line? Would it be dangerous to leave it draped over the valve cover or in front of the cover? (b/c of heat off of it??)
Thanks