FST rear bow measurement (1 Viewer)

[miller]

I have rear bow that got damaged on both sides at the bends. Fabbing a new piece but unsure what rear bow height should be. I need a measurement from top of quarter panel channel to center of rear bow fastener both sides. I just bought this set so I do not have any previous measurements. Thanks

 

[EWheeler]

@miller Check out post 19 here for a reference.

DIY OEM soft top bows

I used to have a web site about making the OEM soft top front bow from OEM hard top sides, but my ISP took it down and I don't remember where I put the back up for the html code. I didn't think that there was any interest in doing this anymore because of commercially available reproduction bow...

forum.ih8mud.com