front speaker component set question (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 4, 2004
Threads
24
Messages
311
Location
Houston, TX
I plan on installing some MB Quart component sets tomorrow and looking at the crossovers there is a low input/high input. I haven't taken the panel off yet, but is there one set of input wires for the tweeter and one set of input wires for the woofer? and if so are you putting them in the high/low inputs or just inputs in one? I had these in a suburban earlier and looks as if the pins inside the crossover were set to have only the low input and it ran the set.

Thanks
 
Last edited:
I can't remember exactly if there is a seperate wire for Woofer and tweeter, but I am thinking no, I think one wire, then the tweeter is protected by a little capacitor to filter out low freqs.

I think the input selections on the crossover is just to select if you are running seperate amplifer inputs to each speaker or "bi-wire". I think you want to just use one input and move the jumper to parallel the second input
 

Users who are viewing this thread

Back
Top Bottom