Been a while since I last posted, my computer finaly went kaput after all those years. Got alot done with the new cruiser in the past few weeks. I got the body sitting up on blocks/planks now, I jacked it up and pulled the frame out. Everybody said it was impossible, but one day I just did it. Had to jack up the body untill I could see between the frame and body, then insert planks. Put the blocks out far enough to clear the frame and planks high enough to clear the 33s. Used two jacks in the front and two in the rear, had to lift the body quite a bit, over a foot easy.
Now my frame is in the best local welding shop getting repaired. Ive been picking at the body as well, its not that bad except for the rear lower hatch. I painted the grille charcoal grey and been cleaning the underneath of this thing, its gross under there.
Today I promise I'll take pics of both cruisers, but only with a cell phone cam. Didn't set up the card reader on this computer yet but shouldnt be a prob. I'll go in town and take pics of the frame too.
Hildy
Now my frame is in the best local welding shop getting repaired. Ive been picking at the body as well, its not that bad except for the rear lower hatch. I painted the grille charcoal grey and been cleaning the underneath of this thing, its gross under there.
Today I promise I'll take pics of both cruisers, but only with a cell phone cam. Didn't set up the card reader on this computer yet but shouldnt be a prob. I'll go in town and take pics of the frame too.
Hildy