FrackMackers Build Thread (1 Viewer)

[FrackMacker]

I’ve been at it for a while but I thought it would be fun to start a thread for my 80 build - purchased Sept 2019

My friend Hunter was selling his to raise funds for a home purchase

since then I’ve been a little busy...

 

[FrackMacker]

multiple fuel pump failures

A few upgrades:

 

[FrackMacker]

cooling system overhaul: thermostat, PHH, rear heater bypass, O-rings, Fan Clutch, etc.

New spark plugs and wires

 

[FrackMacker]

carbon cleanup and emission system overhaul:

adapted evap canister for getting rid of the negative pressure in the gastank

 

[FrackMacker]

I noticed some fluid leaking out of the transfer case at the speed sensor - I replaced an inexpensive O-ring and problem solved

 

[FrackMacker]

After some trouble with rusty locked steering components during an alignment I opted for the steering upgrade kit from Marlin Crawler and replaced the factory tow points for trail tailor

 

[roadstr6]

After some trouble with rusty locked steering components during an alignment I opted for the steering upgrade kit from Marlin Crawler and replaced the factory tow points for trail tailor
View attachment 2532974

Better paint those 555 TRE's or they will rust to Hell.

 

[FrackMacker]

Better paint those 555 TRE's or they will rust to Hell.

 

[FrackMacker]

Better paint those 555 TRE's or they will rust to Hell.

thanks I did see a warning in the packaging but they didn’t really say what exactly might rust

 

[FrackMacker]

pretty sure this isn’t supposed to look like this

 

[Roxx]

Not. That looks damage to me.

pretty sure this isn’t supposed to look like this
View attachment 2537086
View attachment 2537087
View attachment 2537088
View attachment 2537089

 

[jfz80]

You skipped over the shiny gray springs part . Looking good.

 

[GLTHFJ60]

Definitely spindle bushing damage. An artifact of either a blown birfield or more likely, a worn out set of wheel bearings.

Keep it up!

 

[Ncrunner4x4]

Good to see the details of the build, when are we hitting some trails?

 

[FrackMacker]

Definitely spindle bushing damage. An artifact of either a blown birfield or more likely, a worn out set of wheel bearings.

Keep it up!

yeah the wheelbearings had a lot of discoloration ; I assume they got really hot

 

[FrackMacker]

Good to see the details of the build, when are we hitting some trails?

soon I hope! I’m gonna check the other side, and order that 4x4labs rear bumper diy kit

 

[FrackMacker]

@Mungle and I knocked out the valve cover gasket, plug seals and small o-ring on the distributor last night; FIPG on the half moons, check

View attachment 2564433

 

[FrackMacker]

I guess I should’ve done those axle seals while I was in there...