Hi.
I took my Rebuilt A440F transfer case, and put it on my H55F, the swap went well (I hope), but I am confused about the preload and the FSM doesn’t specify well.
What/how do you preload the front AND rear companion flange stake nuts? The FMS says that the nut must be torqued to 94-FT pounds- that seems really high!
But more over, after you torque it to 94 FT pounds, it says to preload check at 6.1 - 10.4 In.-lb or 0.7 - 1.2 Nm
I don’t understand….. I really don’t want to wreck my transfer case…… how can there be a torque spec AND a preload??????
I took my Rebuilt A440F transfer case, and put it on my H55F, the swap went well (I hope), but I am confused about the preload and the FSM doesn’t specify well.
What/how do you preload the front AND rear companion flange stake nuts? The FMS says that the nut must be torqued to 94-FT pounds- that seems really high!
But more over, after you torque it to 94 FT pounds, it says to preload check at 6.1 - 10.4 In.-lb or 0.7 - 1.2 Nm
I don’t understand….. I really don’t want to wreck my transfer case…… how can there be a torque spec AND a preload??????