FJ62 LED swap out (1 Viewer)

[Octave Zangs]

I don't see any references to the transfer switch light, did you change it to?

 

[nomadsurfer]

not sure what you mean by transfer light.

 

[Octave Zangs]

not sure what you mean by transfer light.

I attached a picture! But apparently it requires to swap the LED buld into OEM bulb base (#174) for both transfer switch and AC.

Did you use LED for your rear turn signal lights too?

Thank you for sharing all those info!

 

[nomadsurfer]

Ah the H4 transfer button. No I didn't mess with it.

As for the turn signals I haven't changed them out yet. Didn't want to get into no load electronic flashers, but now I am considering to go this direction. See this post and read to the end. They look very promising.

LED tail lights

 

[Octave Zangs]

Cool! That sounds good!

 

[Spook50]

Not sure why I didn't realize it at the time, but the parking light suggestion (WLED-WHP9) is almost too long and presses against the lens of the assembly when installed. After a quick search the WLED-WHP10 is slightly shorter and puts out just a bit more lighting than the WHP9. I would suggest this as a better way to go. I'll be ordering some when I get the opportunity.

 

[franklin40]

old thread dig up here but for all of you who have done the led dash lights do you find the high beam indicator to be more bright than before. it’s the only light on my dash that i think is too bright at night and don’t want to make it brighter. i’ve ordered all the dash lights but am not sure i want to put that one in

 

[NookShneer]

Defrost Button

The LED should also work in the 62 defrost button, your re-using the OEM bulb holder and swapping in the LED.

 

[CaptHamster]

old thread dig up here but for all of you who have done the led dash lights do you find the high beam indicator to be more bright than before. it’s the only light on my dash that i think is too bright at night and don’t want to make it brighter. i’ve ordered all the dash lights but am not sure i want to put that one in

I put an LED in the high beam indicator, and almost immediately put the old one back in. Totally agree, it was way too bright and while it looked nice during the day time, it killed my eyes on dark dirt roads at night, kinda ruined my night vision. I'd say stick with the original bulb if I were you.

 

[Ramayo84]

hey guys, I bought Red LEDS for the BRAKE/RED taillights from SUPERBRIGHTLEDS but when I tried to put them in but they wouldn't turn when I tried to put them on.

anyone know which are the correct ones?


in the picture is the Stock bulb, and the LED that SUPERBRIGHTLEDS sent me .