- Thread starter
- #21
It took some work, but I now have the HVAC system totally removed. After removing the system, I completely disassembled the four primary assembly units.
1) Intake blower
2) AC pass-through
3) Air mix/heater
4) Rear blower/heater
The entire system was loaded with so much foam dust and lots and lots of other crap. Unreal!!! I cleaned every component, and removed all the failed foam that still remained. I have a new AC evaporator ordered, and currently shopping for replacement foam. Next, I plan to remove the firewall heat shield with the intention of pulling off the original insulation padding, and replacing it with new better padding.
Now that I know the source of all the foam dust isn't the dash pad like I assumed, I'm going to seal all of the edges of the cap covering the original dash pad, no need to replace or recover it!!!
1) Intake blower
2) AC pass-through
3) Air mix/heater
4) Rear blower/heater
The entire system was loaded with so much foam dust and lots and lots of other crap. Unreal!!! I cleaned every component, and removed all the failed foam that still remained. I have a new AC evaporator ordered, and currently shopping for replacement foam. Next, I plan to remove the firewall heat shield with the intention of pulling off the original insulation padding, and replacing it with new better padding.
Now that I know the source of all the foam dust isn't the dash pad like I assumed, I'm going to seal all of the edges of the cap covering the original dash pad, no need to replace or recover it!!!
Last edited: