FJ62 4speed manual conversion (1 Viewer)

[InsanityIsBorn]

I am going to be installing a 4speed manual transmission into my 1988 FJ62. I have everything I need, but when I was looking at my 3F bellhousing I noticed that the pivot pint for the clutch fork is missing. Does anyone know where I can get this part? What is it called? Thanks


Kiel

 

[TBIFJ40]

What transmission and bell housing are you using? If its a FJ60 transmission, you'll probably have to use the bell housing etc etc off the FJ60. 62s didnt have manual trans in 'em. You'll also be loosing your overdrive..... The drive shaft lengths are different between the two models as well because of the trans length difference.

 

[InsanityIsBorn]

I've got all that figured out I am just missing the pivot point for the clutch fork of the FJ60 bellhousing.

Just trying to figure out what that part is called.

 

[zuluzeugma]

I think I have one laying around some place I'll send you if you want it... Its called "clutch release arm pivot"
I'll look for it and PM you if I find it in my "box of metric fun"

 

[Elbert]

I believe SOR has them?