Hello everyone.
I was wondering if I could get a few reference measurements from a few people. I am kinda stuck with a chicken/egg problem on my hybrid build....
Blender, My LX450/FZJ80 + FJ45esk + GM + Land Rover crazy concoction
I am right in the middle of making a custom tunnel for the vehicle. To make the tunnel I need to know where the transmission shifter should end up. To know where the shifter can go I need the to know where the seats will go. To know where the seats can go I need the tunnel to be finished. It is this evil circle.
Anyways.
Can I get a few people to measure roughly how far from the firewall to the front of the seat when it is in the full forward position? I think that will me get a better idea where to set things. I have never had anything other than the bare FJ40 tub to play with.
If someone is bored, perhaps a few measurements on where the shift lever is in relation to something like the firewall or perhaps the lower corner for the dash.
Thank you for the help.
I was wondering if I could get a few reference measurements from a few people. I am kinda stuck with a chicken/egg problem on my hybrid build....
Blender, My LX450/FZJ80 + FJ45esk + GM + Land Rover crazy concoction
I am right in the middle of making a custom tunnel for the vehicle. To make the tunnel I need to know where the transmission shifter should end up. To know where the shifter can go I need the to know where the seats will go. To know where the seats can go I need the tunnel to be finished. It is this evil circle.
Anyways.
Can I get a few people to measure roughly how far from the firewall to the front of the seat when it is in the full forward position? I think that will me get a better idea where to set things. I have never had anything other than the bare FJ40 tub to play with.
If someone is bored, perhaps a few measurements on where the shift lever is in relation to something like the firewall or perhaps the lower corner for the dash.
Thank you for the help.