- Location
- United States
I looked through the swine thread but I didn't see any repro links. Is somebody making them or am I going to have to fab some?
I'm about to do the pre-emptive strike against the rust. I can see my paint bubbling up. I bought a da sander, grinder, a pocket full of disks for the angle grinder, and a sand blaster. Just need to get a sawzall and a welder.
Has anybody made these? I'm also open to a BEEF rocker that would tie into the frame down low but look semi factory from the side. Maybe angle iron stitched to the old metal.
Anybody done the work (I'm sure someone has; maybe the question should be who)?
Thanks-Josh
I'm about to do the pre-emptive strike against the rust. I can see my paint bubbling up. I bought a da sander, grinder, a pocket full of disks for the angle grinder, and a sand blaster. Just need to get a sawzall and a welder.
Has anybody made these? I'm also open to a BEEF rocker that would tie into the frame down low but look semi factory from the side. Maybe angle iron stitched to the old metal.
Anybody done the work (I'm sure someone has; maybe the question should be who)?
Thanks-Josh
