Finishing my AHC delete today, just one question... (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 26, 2003
Threads
58
Messages
729
Location
Frankfort, KY
I'm finishing up the ahc delete today and have one question I've not been able to track down an answer for. I'm installing factory LC torsion bars, but I'm not sure how to index them when I install them. Do I line up the "master spline" on the LC bars with the same place as the LX bars? The only info I've found is for indexing new OME bars, or re-indexing factory installed bars.
 
Brizzle did a great tutorial on changing the TBs, check out his vid.

 
Odds are you will have to remove and adjust one if not a few times. Use the above video and then adjust as needed.
 

Users who are viewing this thread

Back
Top Bottom