I recently purchased a used factory roll bar for a 79 BJ40. I would like to install it in the stock position with stock hardware. Does anyone have a schematic or pictures of a factory setup from above and below the wheel well? I'd like to know if the factory install included plates below the wheel well for added support of if bolts were welded to the underside of the tins.
The reason for installing the roll bar if so I can install three point seat belts and the rear belts for the jump seats. My BJ did not have any belts and I am considering purchasing CCOT's full aftermarket setup. I would also appreciate a picture of the factory mounting points for the seatbelts. It seems like my vehicle is also missing the factory bolt holes for the front seatbelt latch that bolts to the floor between seats.
Thanks in advance
albert@albertrodrigues.com
The reason for installing the roll bar if so I can install three point seat belts and the rear belts for the jump seats. My BJ did not have any belts and I am considering purchasing CCOT's full aftermarket setup. I would also appreciate a picture of the factory mounting points for the seatbelts. It seems like my vehicle is also missing the factory bolt holes for the front seatbelt latch that bolts to the floor between seats.
Thanks in advance
albert@albertrodrigues.com