fabrication (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 11, 2005
Threads
172
Messages
794
Location
morristown nj
i need a favor...
i am throwing around an idea for a rear bumper for my 60 series, with a swing away tire carrierfrom a 40 series
can some one privide me the measurements BETWEEN the upper and lower
pivots?
and also the width and height of the upper pivot, that bolts to the body?
thanks!
hammer
 
bump
 
This one?

Not sure if this is what you are looking for - I just bought my 40 a couple of weeks ago and still trying to figure everything out....

Between pivots = 9 1/4" plate to plate. Plates are both offset a little to the bottom, so the measurement between the hinges themselves is 9 1/4" as well.
Top hinge plate is 2 13/16" accross, and 3 3/16" in height.

I guess because it's a Toyota, I should have given you the metric measurements, but I couldn't find my metric ruler. :flipoff2:

Hope I got it right. Good luck!
web.JPG
 

Users who are viewing this thread

Back
Top Bottom