Extra fuse

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 3, 2003
Threads
86
Messages
7,184
Location
McCall, ID
So, as I was diggin around under the cowl vent today on my 71 I found an inline fuse on a green wire/red line. Looks OEM. Fuse itself looked OK, but the ends were corroded, so I replaced it while I was in there. The only way to get to it that I could see was through the cowl vent, where it was wrapped to the main cable and hooked to the inside firewall. Anyone recognize what this is for and where it leads? I am not finding it on my circuit diagram, but maybe I am missing something.
 
Looked at my '73 harness. No such thing as an in line fuse in the area. The area is a common place for aftermarket radios. I bet it was a PO "enhancement", especially by the fact it was wrapped around the harness.

Dave
 
Glass tube, type. Wiring looks OEM. I was looking at one of the the circuit maps on the tech page, and they seem to have one (although it is 10 amp) on a GR wire between the hazard warning switch and the turn signal switch (not in my manual). Maybe that is it. The emergency flashers are messed up, so that could be part of it. I just need to get into that spaghetti among the e flasher switch, eflasher flasher, flasher, turn signal switch, and my PO's original adjustments to it all. :D >:(
 
Whoah! The eflashers now work (if I don't press on the brake pedal). They never did that before. Think I figured something out!
 
That's cool. It's kind of like an unintended little victory. I love those (except I've got a lot of the "luck of the Irish" - meaning, I get a small victory like that, two days later, I've got 3 flat tires or the electric bill shows up and it's $450 or something...)

But, as Charles Shultz once said "happy endings aren't funny" :)
 
Yah, it will be nice to have them when the headlights go out again (Still hoping the new switch fixes that).
 
good call on that one idave


did just your headlights and gauge lights go out? i'm havin the same problem if so. argghhh


malphrus
 
Yep, just headlights and dash gauge lights. But they haven't gone out since Friday night. :P And only 2 times in the two weeks previously. I'll see if the replaced switch works.
 
nice,

yeah, i went thru and checked the fuse box out a couple weeks ago and got em workin.

then one of my buds took the cruiser (argghhh) that night and parked it with the lights on (or at least the switch pulled out).

got there in the mornin and the battery was fine, but the lights were out.
says he doesn't remember if the lights were on or off when he left it.

since then, no lights.
gonna get to work today on makin a new fusebox setup. also gonna check out the switch.

what goes bad on the switch?



malphrus
 
What goes bad? I don't really know, but it must be an insulation thing, because it must be arcing or somehow shorting out. I noticed my headlight fuse got so hot it would blister my finger. That tells you something. And the contact on the switch was blackened. I once had one literally fall apart in my hands. I think the plastic the switch was made of is cruddy, for one thing.
 
Dave, I had a problem where the PO wired it so too much current was going through the circuit melting the wire insulation. It was hot to the touch. He tied the radio into the headlights. Could something similar have caused your switch to overheat?
 
As far as I recall, there is nothing but the headlights on that circuit. There is only one wire coming off of that side of the fuse. But I may have tied in my tach light. I went over it pretty carefully. All of the wires look intact.
 
Back
Top Bottom