ESCAPE GEAR SEAT COVER : LC200 INSTALLATION QUESTION

[7000ft]

I'm attempting to install my escape gear front seat headrest covers in my 2020 LC200.
No no matter how tight I fit them I cannot attach the velcro strapping .
I switched covers and it went with a little stretching.
Other is cut a little to tight, but hopefully it will fit the passenger side.
One cover on....one to go!

 

[TheLCProject]

There's a little release on the connector. Use your fingernail or a little pick to depress the tab. If you can't see it, just follow the wires from the light until you feel the connector and then squeeze where you feel the tabs.

 

[7000ft]

There's a little release on the connector. Use your fingernail or a little pick to depress the tab. If you can't see it, just follow the wires from the light until you feel the connector and then squeeze where you feel the tabs.

Got it! Thank you!!

 

[TheLCProject]

For as easy as the covers for the seat bolts come off, I'd really consider easing my frustration by just removing the bolts and and tipping the seat back. I had my seat loosened up for another reason and fixed/rerouted the straps from my first install attempt.

 

[7000ft]

For as easy as the covers for the seat bolts come off, I'd really consider easing my frustration by just removing the bolts and and tipping the seat back. I had my seat loosened up for another reason and fixed/rerouted the straps from my first install attempt.

Second one was much easier. Maybe an hour for that seat. I spent a considerable amount of time being sure that none of the straps are interfering with the wiring hopefully everything is out of the way both seats seem to function just like they did without the covers. Total time in the garage 4 hours.