I am trying to pull the 2F engine out of my 1986 FJ60. I think that I have everything broken loose. I put the jack under the transmission and used a hoist to the lift hooks. NADA! The motor won't break free. I am trying to separate the bell housing from the transmission. I have removed 4 bolts from the transmission into the bell housing. Is there something that is not obvious that I have missed? (Detached Items: exhaust pipe, all hoses and wires, front motor mounts, clutch slave, starter, fuel iines and pump, AC compressor, power steering, carb linkage, etc). Is it just binding at the trans input shaft? I have pried on it but the force just gets transfered back to the transmission. Any suggestions would be appreciated. Must return the lift Tues AM.