1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Eliminate Single Shear, good for Shocks AND Coilovers!

Discussion in 'Drivetrain - Suspension' started by Dan Fredrickson, Feb 25, 2007.

  1. Dan Fredrickson

    Dan Fredrickson Supporting Vendor

    Messages:
    798
    Likes Received:
    84
    Joined:
    Sep 13, 2005
    Location:
    Sacramento
    How many rigs come from the factory with a single post for the lower shock bracket? Thats right, Lots of em, and its a real weak point. With the inspriation from our 3 Legged Link Brackets we developed these Shock Brackets. They are a 3 piece design with the main section bent and the secong tab is a slider that you can position for YOUR application before you weld them up. The third piece is a "floor" to add rigidity and strength, they are 1/4" thick and mount directly to the side of the axle.They will fit from the 1 1/4" to the 1 3/4" pin eye mounting points, that pretty much covers all the coilovers and standard shocks made! They eliminate single shear and position the Pin Eye correctly for maximum articulation. They are sold in pairs at $24 a pair!

    [​IMG]

    Again, I am sorry that the pics aren't better, I am much better with steel than a camera!
     
  2. camcruiser13

    camcruiser13

    Messages:
    6,979
    Media:
    3
    Albums:
    1
    Likes Received:
    28
    Joined:
    Jun 22, 2004
    Location:
    sittin on the couch in UT
    you got a pic on a 40?

    i need some
     
  3. Dan Fredrickson

    Dan Fredrickson Supporting Vendor

    Messages:
    798
    Likes Received:
    84
    Joined:
    Sep 13, 2005
    Location:
    Sacramento
    I don't have any pics of these yet......

    We are still setting up the new wharehouse and haven't even been able to install the lifts yet, let alone get any work done beyond shipping........I need a vacation! See you all at Georg's swap in Stockton.