Educate me on coolant leak (1 Viewer)

[jaymar]

Found it. Is this the TB hose y'all were talking about that curves up right near the rear of the fuel filter? If so, then no doubt about small hands...maybe remove the upper intake manifold?

View attachment 2071037

View attachment 2071038

Check out photos here. Manifold can stay in place.

Master Thread P/Ns with Photos (Belts & Hoses)

Thought it might be useful for folks to post photos (and helpful hints) like these in different categories. I'll start off with Belts & Hoses because that's what I'm doing now. It can take hours to track down the right P/Ns; this should save a lot of folks a lot of time. If all such threads are...

forum.ih8mud.com

 

[BILT4ME]

Bypass hose #1.
Search for it, you'll get a lot of good installation tips to.make your life easier!

 

[Noahrob]

This ended up being a pita, but the trick is to use a long nosed small vice grip to get the factory clamp on...

 

[BILT4ME]

This ended up being a pita, but the trick is to use a long nosed small vice grip to get the factory clamp on...

Here's a hint....... Put the factory clamp on the new factory hose FIRST, the spit inside the hose for lubrication, then push it on until it bottoms against the block. You can do it blind.

The FACTORY hose has a white mark on it to align the ears if the factory clamp before you install it.

Makes it very simple and quick!