So I’ve wire up the edic and fuel control relay but EDIC motor won’t move. I’ve opened it up cleaned the brushes and stator cleaned out the old grease and put new grease in and it was spinning by hand. I’ve followed the wiring diagram from my original manual plus one I drew up to mark off as I went along. My question is now why won’t it work ? And is it worth getting an auto electrician to look at or to do the dodgy and make a push pull cable up to the cab to shut the engine off. I just need registration to get it on the road !
Below is pictures of the diagram and in the motor and relay
Cheers !
Below is pictures of the diagram and in the motor and relay
Cheers !