DRL/High Beam (1 Viewer)

[4 RunnerJDM]

Hi guys,
Today, i installed most of the bulbs (interior/exterior) to LEDs and for some reason after I installed the low beam bulbs, the DRL/High beam does not work.
Can someone please help?
I checked the fuses and they are good.

Thanks.

 

[Greenbean]

IIRC its a resistance thing and the factory DRL circuitry runs the incandescents at a lower voltage, since the LEDs are very very low resistance when compared the factory incans it gets a little involved tricking the system.

Read through this thread, it may offer some insight.

LED DRL and High Beam for LX and LC

Page 4 has a possible solution for the 98-2002 to run this setup 2003-2007 LED DRL/HIGH BEAM KIT The LED DRL /High Beam Kit is now available in a limited quantity on my site www.lbbuiltwerks.com . The kit will include the 2Stroke LED bulbs a resistor and a harness. The kits vary based on LX...

forum.ih8mud.com

 

[4 RunnerJDM]

IIRC its a resistance thing and the factory DRL circuitry runs the incandescents at a lower voltage, since the LEDs are very very low resistance when compared the factory incans it gets a little involved tricking the system.

Read through this thread, it may offer some insight.

LED DRL and High Beam for LX and LC

Page 4 has a possible solution for the 98-2002 to run this setup 2003-2007 LED DRL/HIGH BEAM KIT The LED DRL /High Beam Kit is now available in a limited quantity on my site www.lbbuiltwerks.com . The kit will include the 2Stroke LED bulbs a resistor and a harness. The kits vary based on LX...

forum.ih8mud.com

Thank you for your help.
I will read up on this.