Took the bolts to Napa and they did not have replacements but said they were M8 1.0-30. My limited knowledge says that are Grade 8, thread pitch 1.0, 30mm in length. Which I believe is the OEM standard, correct? I think the 13mm head was throwing me off. Based on that size, does anyone know which year that would fall into? As mentioned earlier, this is titled a '69, but lots of upgrades were done and not sure if/how to know if the driveshaft/flange is from newer FJ. I was able to find some bolts at Home Depot, but not the nuts or washers. They were Zinc plated and I'm not sure what they are supposed to be.
@RAGINGMATT Really appreciate all the insight. I would prefer to support one of the vendors on here and saw SOR and Cruiser Corps had on their sites. I need to email them to make sure I get the right year based on the bolt size. It is interesting you mention the parking brake as they is on my list as well plus new pads. This vehicle was given four wheel disc brakes, so I will need to figure out how to tackle that with the upgrades.
@RAGINGMATT Really appreciate all the insight. I would prefer to support one of the vendors on here and saw SOR and Cruiser Corps had on their sites. I need to email them to make sure I get the right year based on the bolt size. It is interesting you mention the parking brake as they is on my list as well plus new pads. This vehicle was given four wheel disc brakes, so I will need to figure out how to tackle that with the upgrades.