Wanted Drive Flanges (80 or 100 series) (1 Viewer)

sdnative

SILVER Star
Joined
Oct 28, 2007
Messages
4,394
Location
San Diego
Looking for a pair of drive flanges for my 100 series, preferably w/ stripped spines. I believe the 80 and 100 are identical other than the spline count? If otherwise different, please let me know. I am planning to bore out the splines and use as trail spares.
 

sdnative

SILVER Star
Joined
Oct 28, 2007
Messages
4,394
Location
San Diego
Thanks for the info. I guess the 80 flanges are out.

I would love to have an ARB front (and rear), but it's not in the build plans, at least in the short term. Of course if I break my front diff that could change.
 

ginericLC

Wagon Wheeler!
Joined
Jan 29, 2003
Messages
7,684
Location
MH, IDaho
I broke my front diff in my 100. So now on any future 100s an ARB is a must before other mods. In my case I wasn't even wheeling. I was on a gravel road going up a hill and lost traction and the next thing I knew it popped. You have the later diff so you might be OK. I wouldn't invest too much time and money in making flanges. If it does break just pull the flanges and cover them with some paper towels and duct tape them shut. As long as you don't submerge them in water you'll be fine.
 

Users who are viewing this thread

Top Bottom