Does anyone know what this is? It came from bell housing I think. (1 Viewer)
- Thread starter nerdalert
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
It's the fulcrum for the fork that presses the throw out bearing. The name escapes me.
Yupper... clutch fork pivot pin, basically. (The two clips tucked in there are for the end, just there for safekeeping while it's disassembled)
- Thread starter
- #4
You are a life saver!!!! I spent over an hour trying to figure out where it went.
It's like I have a cutaway model of the FJ40 with all of the parts in my basement at the moment. 
At least they're migrating to the chassis again... hoping to have the engine and trans together and back in next week.
At least they're migrating to the chassis again... hoping to have the engine and trans together and back in next week.
It came from bell housing
Sounds like a horror movie title!
