cruiser_guy
Out of Africa / North Africa
I posted in my "Can this birf be clearanced" thread to try to keep all this info in one place but no one noticed so here it is again.
I have clearanced the axle and taken my measurements with the OEM knuckle centering tool. After I've gone through the formulas I end up needing a NEGATIVE number of shims on the bottom and about 2.5mm on the top (total shim requirements on both sides came to less than 3mm)!
Does that make sense? This is a '67 axle with a mini disc conversion
I have clearanced the axle and taken my measurements with the OEM knuckle centering tool. After I've gone through the formulas I end up needing a NEGATIVE number of shims on the bottom and about 2.5mm on the top (total shim requirements on both sides came to less than 3mm)!
Does that make sense? This is a '67 axle with a mini disc conversion