Builds DINGO- 60FZJ-UTE LS3 EROD (PROVEN CA SMOG) (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

A few more items off the punch list. Good 4 hour morning.

Designed a fuse block bracket for the LS3, tapped in for CC vent and got the intake set, overflow bottle mounted, got the evap canister, purge valve and evap vent positioned out back by the tank, filled with Dexos Pennzoil full syn oil. Installed TruckLite Military heated LEDs.

J


IMG_20190907_112742611.jpg
IMG_20190907_111005496.jpg
IMG_20190907_113121306.jpg
IMG_20190907_110928570.jpg
 
Last edited:
Wow, another build lined up & you haven't even started the Ram (to my knowledge)!
 
Last edited:
Once SMOG is complete
(BOXED ELEMENT CONCEPT)
View attachment 2074197

Ha! I designed that airbox when I worked at Airaid, it was originally for the 4.0L found in Tacomas and 4Runners. Should flow plenty of air for your E-Rod. You can't tell from this pic, but there is a hole on the right side that you can't see. Usually you would use a velocity stack there and connect to the TB. I hope they would include the velocity stack wit the box since it also shows the lid and gaskets. The round opening on the left with the foam gasket sticks through the inner fender to pull cold air. Not sure how this will lay out in your engine bay, but that was the original intent.
 
A lot of cool sheet going on in your shop! Looking forward to it!

I never should have sold HAMP.. not a good time being on assignment in TX....

A lot of "SHEET" is about to happen... I may need a trip to Dittmer to relax and just wrench and play... Maybe a catfish or crappie or two.

J

1568427885742.png


1568427915664.png


1568427969765.png
 
Last edited:
Hamp is for sale by the guy that bought him off of me. I think he was asking $15k.
 

Users who are viewing this thread

Back
Top Bottom