Dang IT! (2 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 30, 2006
Threads
73
Messages
442
Location
Virginia Beach
My dilemma in mounting my Metal Tech Sliders that I just picked up. I have an extra bracket that was put on when I got my lift. Do I need it? I believe it is there to keep the caster? angle correct. Can I remove it and not effect the angle to bad? I have a 3 inch lift with J springs.
DSC07613.jpg
DSC07615.jpg
DSC07612 - Copy.JPG
 
your mom
 
and land tank
 
What bracket is that? Who makes it?
 
Who is in the background?
 
you "might" be able to notch the man a fre bracket so the ubolt can fit through, would have to see it in person.

Noah

Thought about that but there is not enough room for the bolt to go through.
 
I got some new castor bushings that I'm not using. They're FOR's bushings and I think they're for 3" lift.

You can give these a try and if they work, give me maybe $50 for them. If not, take them off and go for plates, Slee's or LT's.
 
there's no way that will be notched and retain any strength.
Ditch the MAF stuff.
 
3" lift you would be fine with castor bushings or plates. If it were me I would sell the MAF brackets, get some bushings or plates and enjoy the extra ground clearance and Metal Tech protection. But that is just me. :grinpimp:
 

Users who are viewing this thread

Back
Top Bottom