Dakota Digital with H55F speedo cable help (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 7, 2014
Threads
109
Messages
868
Location
Lancaster, CA
Hey everyone,
Has anyone hooked up a Dakota Digital to an H55F? Is the speedo cable that comes with the kit all you need? When I look at the plastic square male on the cable from the kit there doesn't seem to be a matching female counterpart on the t-case? Am I missing something?
thanx
Craig
 
The speedometer Drive gear with the female square reciever u are looking for goes in the upper LH side of the Rear seal extension

Housing shown here

u might need the Drive Gear Kit if all u have is the Hole where is goes ?

its like a 17mm bore if i recall correctly

its held in by a flat metal Tab / Retainer and a 12mm hex very short SEMS bolt
 
1968717



sorry for the SOR SPAM , but only image i could find on short notice of where the Drive Gear Kit Sleeve installs




DSCN9904.JPG
 
Mine came with a small brass piece that adapts the square drive to a keyed end which fits the into the splitcase extension housing. Hope this helps.
DSCN1455.JPG

DSCN1456.JPG

DSCN1459.JPG

DSCN1458.JPG

DSCN1460.JPG
 
Ok, that's what that little piece is for....thanx!
 

Users who are viewing this thread

Back
Top Bottom