I've got a quite a bit of `crap' where the PO cut out the rear wells for plastic flares, but the flares are since off and each area needs some help. In my best world, I prefer to have the original metal there; is there a clean way to weld/grind back in the metal?
If no & since this will get larger tires anyway, what is the most preferred lines/method of cutting this away? I've seen quite a few people cutting back the side metal right under the bed sides all the way aft.
If no & since this will get larger tires anyway, what is the most preferred lines/method of cutting this away? I've seen quite a few people cutting back the side metal right under the bed sides all the way aft.