I'm doing a flush with thermocure since everything inside is rusty. Likely I'll be replacing the radiator but just wanted to try the thermocure first to see if this helps. Will also be replacing fan clutch as well while I'm at it.
I'm on my first flush and running the thermocure around to help clean everything up without the thermostat. However, it seems like the heat never gets hot even though the temperature gauge shows that it's in the middle. Is this because by the time the thermocure gets to the heater core it's cold? I've already been running the radiator without the cap on incase there is air in the system.
Thanks!
I'm on my first flush and running the thermocure around to help clean everything up without the thermostat. However, it seems like the heat never gets hot even though the temperature gauge shows that it's in the middle. Is this because by the time the thermocure gets to the heater core it's cold? I've already been running the radiator without the cap on incase there is air in the system.
Thanks!