I just serviced my knuckles today following this tech thread-
https://forum.ih8mud.com/80-series-tech/78276-front-axle-rebuild-faq.html
I can't however find a few torque values in that thread of by searching. I need the torque value for the control arm to knuckle studs (the lower 17mm nuts that utilize the tapered cone washers). And I also need the torque value for the 6 small (10mm) bolts that hold on the wiper seals (probably just a few in/lbs).
https://forum.ih8mud.com/80-series-tech/78276-front-axle-rebuild-faq.html
I can't however find a few torque values in that thread of by searching. I need the torque value for the control arm to knuckle studs (the lower 17mm nuts that utilize the tapered cone washers). And I also need the torque value for the 6 small (10mm) bolts that hold on the wiper seals (probably just a few in/lbs).