- Joined
- Oct 31, 2008
- Threads
- 67
- Messages
- 815
- Location
- Napa Valley California
- Website
- www.mosscreekwinery.com
I took apart my 1969 (9mm brake lines)rear brakes apart to inspect and clean up the cylinders. Cleaned up cylinders and decided to swap for 10mm cylinder. Did a front disk conversion earlier.
So here is the picture. Why don't I have the clip and pin (looks like a nail) to hold the brake shoes in place? BTW there is no hole in back plate for pin. Should I drill a hole and put a pin in place?
So here is the picture. Why don't I have the clip and pin (looks like a nail) to hold the brake shoes in place? BTW there is no hole in back plate for pin. Should I drill a hole and put a pin in place?