Hi,
I have a question about clearance between clutch cover and T/O bearing when pedal isn't pressed.
My FJ62 has manual transmission and used same parts & mechanism about clutch with later US FJ60.
Until a few days ago, I thought that there's a little clearance exists between clutch cover spring and t/o bearing but after did comprehensive checking about my FJ62's clutch system, I found that there are no clearance always.
So it means that T/O bearing is always rounding and rounding.
When I press the slave cylinder rod and give clearance, it return to contact bearing and clutch cover.
Is it OK ? or if it's not correct situation, is there any way I can correct this ?
Attached photo was taken when clutch pedal wasn't pressed.
I saw that pre 84 clutch system had fork return spring but mine don't have.
If anyone knows about this, please inform me.
Thank you,
Oh, Min Seok
I have a question about clearance between clutch cover and T/O bearing when pedal isn't pressed.
My FJ62 has manual transmission and used same parts & mechanism about clutch with later US FJ60.
Until a few days ago, I thought that there's a little clearance exists between clutch cover spring and t/o bearing but after did comprehensive checking about my FJ62's clutch system, I found that there are no clearance always.
So it means that T/O bearing is always rounding and rounding.
When I press the slave cylinder rod and give clearance, it return to contact bearing and clutch cover.
Is it OK ? or if it's not correct situation, is there any way I can correct this ?
Attached photo was taken when clutch pedal wasn't pressed.
I saw that pre 84 clutch system had fork return spring but mine don't have.
If anyone knows about this, please inform me.
Thank you,
Oh, Min Seok
Last edited: