CLCC Lift Day? (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Only going 3" this go round. My last couple of projects went a little/ lot overboard and trying to keep this one driveable.
 
GETTING THE ITCH......

HAVE SPRINGS AND SHOCKS, GOING TO MAKE SWAY BAR EXTENSIONS....

hOW LONG SHOULD THIS TAKE. NO SPRING COMPRESSOR. HOPING FOR A LIFT...
 
It depends on how much “free all” you are presoaking the nuts and bolts with. It shouldn’t be too bad. When I did mine I had to stop mid day because I couldn’t get the bushings out and the castor correction bushings in. As previously mentioned I had to have @OTRAMM do that part. But I don’t remember it being too crazy. I was doing it all solo so it was a pain at some parts with no lift to use. With any help you will get it done for an early supper I bet.

I’m jonesing to do mine as well.
 
I know its Friday, but spontaneous plans are fun. Anyone in???? LOL
 
This weekend...

I am free all weekend...

Saturday is the Club Holiday party..... We should do it there.... Ha HA
 
I may actually attempt this tomorrow.....

Front brakes while I am there and the lift. Should be good to get it in one day if I get that lift........
 
Didn't get this done.... Oops!

Scheduling a date, Now.

January 5th, 6th.

I will be at my shop on January 5th at 2pm. I have to work that morning.

I will have everything all set and ready to go. And will probably already be under her.

I f I can get the lift to help, all that much better. But not planning on it.

So just stop by and have a drink, eat some pizza and grab a wrench.

I an fairly sober, so I will most likely only have Diet Coke. All else is going to be BYOB.


Would like to get this done so it can be shook down before the February trip.

Thank you in advance for any help and all your support.

Address:
1494 Govenor Bridge Road
Davidsonville, Md 21035

Google Maps
 
Last edited:
Awesome. Thanks, See you tomorrow,
 
@JohnVee If it is just us, I cant have you drive all the way out.... I can wait until Tech day and just drag my stuff there......
 

Users who are viewing this thread

Back
Top Bottom