Builds Classy build (triple locked) 2019 (1 Viewer)

[Eric Sarjeant]

Super fun build we just finished up, thought it would be worth sharing (sold).



2019 Land Cruiser Custom Build TRIPLE LOCKED

• Old Man Emu (OME) BP-51 Suspension
  • 2703 Front Springs
  • 2723 Rear Springs
• SPC Upper Control Arms
• Slee KDSS Relocation Kit
• Slee Rock Sliders
  • Rock Lights (three per side) wired to key fob / dome lights for use as puddle lights or rock lights with override
• 2019 Tundra TRD PRO BBS Forged Wheels (four)
  • 1.25" Spidertrax Wheel Spacers
• BF Goodrich KO2 LT305/65/18 (five)
• Long Range America 12.5 gallon long-range fuel tank
• Front Runner Slimline II Roof Rack
  • With Stainless Steel Pro Table
  • Lightbar Mount
• GOBI Ladder
• Lights:
  • Lightbar: Baja OnX6 40" Amber/White (Baja SKU: 464014)
  • Spots: 1200 200 Baja Designs LP9 amber (qty 2) - SPOTS amber/driving combo
  • Custom drawer lights installed in tail gate
• Electronics:
  • SDHQ Switch Pro
  • Redarc DCDC (BCDC1240) Custom mount attached to Slee dual battery mount
  • Two (2) Optima Red Top group 35
  • Two (2) 4.8 amp USB ports
  • Two (2) 12-volt outlets
• On Board Air
  • ARB Twin Air Compressor
  • Manifold Kit
• Gearing / Lockers
  • NITRO 4.30 Gears
  • 500 miles break-in drive at variable speeds
  • ARB Front and Rear Lockers
  • ARB Diff Breather Kit
• Front Bumper / Winch
  • ARB Summit with Camera relocation Kit
  • Warn XEON 12 Platinum Synthetic Rope
• Snorkel
  • Safari Snorkel (2016+ LC200)
• Chrome Delete
  • Paint work for grille, headlight surrounds, fog light trim, lower door trim, taillight trim, trim piece at base of upper lift-gate & rear emblems in black satin paint
  • Black satin vinyl installed over chrome strips at base of side windows and fog light bezels
• Paint Protection Film / Tint
  • Front Two - FormulaOne Pinnacle Llumar VLT Ceramic -- 20%
  • Rear Glass - FormulaOne Pinnacle Llumar VLT Ceramic - Rear Doors, Third Row, Tailgate hatch door - 80%
  • XPEL Ultimate Plus PPF - 17" partial hood/fender/mirrors & front bumper kit
  • XPEL Ultimate Plus PPF - XPEL Ultimate Plus PPF - everything below the body side moldings on doors. Straight line at the bottom of the lower door side moldings, starting on the front fender and continuing to small strip between rear wheels and rear doors. Also do the rocker panel and sides of rear bumper
  • XPEL Ultimate Plus PPF - install a 6" strip across the roof from left to right under where the wind deflector could make contact with roof, door cups
  • XPEL Ultimate Plus PPF - Door grabs, door edges
• Security
  • Clifford Smart Start (smart app GPS remote start/tracking) with Alarm $70/yr subscription alarm added to labor, not parts

 

[RumBum]

Oh my!

 

[vipergrhd]

May I ask how much did it sell?
Very nice color and clean look.

 

[Madtiger]

I get two to go please.....


Seriously awesome. Oh, and that is a nice iPhone 11 Pro that is used to film this....

 

[catastrofe]

Nice build. Nice Daytona.

 

[Eric Sarjeant]

May I ask how much did it sell?
Very nice color and clean look.

Sorry, pricing off limits per owner on this post. Of course, I could create custom quotes shoppers needs and wants.

 

[99Cruiser]

How do those tires ride on the 8" wide wheel? Does it feel planted. I was thinking of 305/60/18 on the stock rim but worried about being too wide.

 

[Mogwai]

That truck is awesome Eric, I think we all remember you planning for your first build, and this one has come a long way! And what's really classy though... Is you putting your cell number out there!

Nice work!

 

[Eric Sarjeant]

How do those tires ride on the 8" wide wheel? Does it feel planted. I was thinking of 305/60/18 on the stock rim but worried about being too wide.

It does feel planted. I drove it 500 miles while breaking in the gears and I really like the feel of the whole setup. Definitely a heavy ride! But the whole package with BPs/gears/tires it all fits together like a puzzle. I wouldn’t change much, if anything, this turned out great.

 

[dnh1]

This truck looks absolutely amazing. Perfect.
If I wouldn’t look like a madman driving this as my daily driver given my job, I would get the exact same thing!

 

[bloc]

The only thing it’s missing is a magnussen kit.

 

[Eric Sarjeant]

The only thing it’s missing is a magnussen kit.

We are a Magnuson dealer, but I can’t do LC200. Just Tundra, 4R, Taco. No ECMs

 

[Markuson]

Super fun build we just finished up, thought it would be worth sharing (sold).



2019 Land Cruiser Custom Build TRIPLE LOCKED

• Old Man Emu (OME) BP-51 Suspension
  • 2703 Front Springs
  • 2723 Rear Springs
• SPC Upper Control Arms
• Slee KDSS Relocation Kit
• Slee Rock Sliders
  • Rock Lights (three per side) wired to key fob / dome lights for use as puddle lights or rock lights with override
• 2019 Tundra TRD PRO BBS Forged Wheels (four)
  • 1.25" Spidertrax Wheel Spacers
• BF Goodrich KO2 LT305/65/18 (five)
• Long Range America 12.5 gallon long-range fuel tank
• Front Runner Slimline II Roof Rack
  • With Stainless Steel Pro Table
  • Lightbar Mount
• GOBI Ladder
• Lights:
  • Lightbar: Baja OnX6 40" Amber/White (Baja SKU: 464014)
  • Spots: 1200 200 Baja Designs LP9 amber (qty 2) - SPOTS amber/driving combo
  • Custom drawer lights installed in tail gate
• Electronics:
  • SDHQ Switch Pro
  • Redarc DCDC (BCDC1240) Custom mount attached to Slee dual battery mount
  • Two (2) Optima Red Top group 35
  • Two (2) 4.8 amp USB ports
  • Two (2) 12-volt outlets
• On Board Air
  • ARB Twin Air Compressor
  • Manifold Kit
• Gearing / Lockers
  • NITRO 4.30 Gears
  • 500 miles break-in drive at variable speeds
  • ARB Front and Rear Lockers
  • ARB Diff Breather Kit
• Front Bumper / Winch
  • ARB Summit with Camera relocation Kit
  • Warn XEON 12 Platinum Synthetic Rope
• Snorkel
  • Safari Snorkel (2016+ LC200)
• Chrome Delete
  • Paint work for grille, headlight surrounds, fog light trim, lower door trim, taillight trim, trim piece at base of upper lift-gate & rear emblems in black satin paint
  • Black satin vinyl installed over chrome strips at base of side windows and fog light bezels
• Paint Protection Film / Tint
  • Front Two - FormulaOne Pinnacle Llumar VLT Ceramic -- 20%
  • Rear Glass - FormulaOne Pinnacle Llumar VLT Ceramic - Rear Doors, Third Row, Tailgate hatch door - 80%
  • XPEL Ultimate Plus PPF - 17" partial hood/fender/mirrors & front bumper kit
  • XPEL Ultimate Plus PPF - XPEL Ultimate Plus PPF - everything below the body side moldings on doors. Straight line at the bottom of the lower door side moldings, starting on the front fender and continuing to small strip between rear wheels and rear doors. Also do the rocker panel and sides of rear bumper
  • XPEL Ultimate Plus PPF - install a 6" strip across the roof from left to right under where the wind deflector could make contact with roof, door cups
  • XPEL Ultimate Plus PPF - Door grabs, door edges
• Security
  • Clifford Smart Start (smart app GPS remote start/tracking) with Alarm $70/yr subscription alarm added to labor, not parts

Extremely refreshing to find a Toyota dealer who can not only offer this level at point of initial sale...but also do so having thoroughly researched each element as an active member here as proof of careful planning. I’m familiar with every single piece added there...but I’m an OCD 200 guy. It’s rare for a dealer to become so familiar...and focus on quality rather than just slap parts on for maximum, quick profit. Clearly this was very well done.

Eric did the proper 500-mile gear-swap break -in himself? Wow.

Even the ability to seamlessly breeze through every piece of the video walkthrough demonstrates clear familiarity & obvious, personal involvement throughout the process. Eric is a Toyota dealer/owner who obviously takes this stuff on—himself—rather than just handing if off to some underlying. Nice to see a T owner who ACTUALLY GETS why we are all here in the LC forum.

Nicely done, @Eric Sarjeant !

 

[bloc]

We are a Magnuson dealer, but I can’t do LC200. Just Tundra, 4R, Taco. No ECMs

Time to find a toyota tuning shop that can handle that side of it...

 

[turbo8]

Is there a reason you can't program the LC ecm? Doesn't the LC ecm have the same part number as a Tundra ecm?

 

[OGBeno]

Is there a reason you can't program the LC ecm? Doesn't the LC ecm have the same part number as a Tundra ecm?

No.

 

[bloc]

It has been done but on older trucks that apparently have different ECU encryption. And the older 6spd auto.

 

[Union]

Awesome build. Clever use of the sunglass holder! Did you have to source an older 3rd member for the rear air locker?

 

[Eric Sarjeant]

Awesome build. Clever use of the sunglass holder! Did you have to source an older 3rd member for the rear air locker?

Yes, Nitro typically will have the cores

 

[nor_cal_cyclist]

Thanks for the compliments, guys - "she's" mine. Feel free to shoot me any questions/comments about my build specs.

That truck will also be getting BudBuilt skids (sitting in the garage waiting for the truck), and misc rear suspension parts from @TRAIL TAILOR. Rear bumper TBD - most likely a Trail Tailor item as well, since Jason's shop is only a few miles from my home in Redding. ARB drawers possibly being added once I get the truck and establish if my BIG dogs fit in back with the drawers (hoping so, for the added organized storage).

Thanks @Eric Sarjeant for providing the ability to rather quickly replace another "built truck" and being so easy to work with. edited due to numerous issues during final sale/delivery/registration