Chromoly Birfs Installed

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

very nice site....keep us posted as to what you find/how you like them.

pm sent.
 
Are these bifs intended for heavy duty use and abuse?
Can these be used on daily driver with occasional trail use?
BTW: Great site with lots of info.

Thanks,

______________________
Antonio
1994 FZJ80
 
http://www.toyotasuperaxles.com, or catch the Longfield banner as it rotates in the forum

These are perfect for the daily driver AND the extreme offroad idiot....
 
Did you replace the inner axles as well or just the birfs?
 
Thanks for the nice pic's and detailed info. I was thinking about what one should do on a trail when one breaks and you addressed this a little. I guess you better fix it there with a spare? I couldn't understand which birfield on Longfield's site that you got because there are two shown, a 30 spline and a 27 spline, both 4340 Chromoly, and both say they have smaller balls which allows thicker bell and cage? Would it make sense to get these and just swap out to these the next time you do a birfield re-pack lube if you didn't have a spare to carry? You would have the stronger birf's allready, then you also will have spares to carry with you just in case? Really cool site!!
 
Bryan,
The chromo 80 series Birfs are listed on Bobby Long's site yet. The 27 and 30 spline ones listed are both for mini trucks and earlier Cruisers.

:beer:
 
actionjackson said:
Sorry for the delay. Was out all day on the trail :) These things are definately rated trail tough. I just got back from Carnage and I did all the hard lines including the waterfall without a birfield failure so these things are way tough. I'm impressed. I'll post up my trail report tonight. What a day :doh:


And with 40s!!!! :eek: Must be tough.
 
Just need a little advice. My cruiser has 120k, 6k of those are mine. To date I have had only minor issues with the truck at all, but I have no idea when and if the birfs have ever been done. If I am going to tackle this job would it be silly to get the Longfields and just replace them. I just got a nice tax return burning a hole in my pocket. This is my daily driver and offroader so I dont want start this repack and find out my birfs are worn out. Thanks all :cheers:
 
Baggins, if you are running 33s and wheeling you should be fine. If and when one breaks then make that decision. Once you go above 35s and wheeling the bodily fluids out of your truck it's a good idea to consider this or at least have spares.
 
MaddBaggins said:
If I am going to tackle this job would it be silly to get the Longfields and just replace them. I just got a nice tax return burning a hole in my pocket.

I agree with Junk. That's too anal even for the guys on this board. If they are clicking then that's a different story but at 120K, you should be ok. Just do the birf job and inspect the birfs well.
 
FROM THE WEBSITE I'm not even sure anyone has ever broke the bell housing on an 80. Christo has broke an inner axle before but not the bell.
:D

Like this (granted it a Newfield).
sof_birf.webp
 
Last edited:
sleeoffroad said:
:D

Like this (granted it a Newfield).
How was the condition of the housing (knucle housing) after a test like this? Do you see any scoring at all in the inner housing?
What were the conditions under which this "destructive test" was executed?
What type of torque?
It looks amazing how that thing was shatered.

Thanks,

__________________
Antonio
1994 FZJ80
 
Back
Top Bottom