ERNRAM
SILVER Star
Howdy,
Been gathering parts for a 1986 vintage 2F rebuild for a few months. I'm located in Austin but willing to drive up to Dallas/Ft Worth, Houston or down to San Antonio for an experience 2F Toyota rebuilder who has experience.
Block needs a clean deck, cam bearings and freeze plugs installed. Bores are at 0.75mm over and might need a hone, but if needed based on feedback can go 1.00mm over
Crack looks like it just needs a polish (currently 0.25mm under on both rods and mains, but depending on feedback can go 0.50mm under.
Head needs resurfacing at block side and manifold side. Have all new values, springs, seals, locks, etc.
Any leads who be appreciated.
Thanks
Ernie
Been gathering parts for a 1986 vintage 2F rebuild for a few months. I'm located in Austin but willing to drive up to Dallas/Ft Worth, Houston or down to San Antonio for an experience 2F Toyota rebuilder who has experience.
Block needs a clean deck, cam bearings and freeze plugs installed. Bores are at 0.75mm over and might need a hone, but if needed based on feedback can go 1.00mm over
Crack looks like it just needs a polish (currently 0.25mm under on both rods and mains, but depending on feedback can go 0.50mm under.
Head needs resurfacing at block side and manifold side. Have all new values, springs, seals, locks, etc.
Any leads who be appreciated.
Thanks
Ernie