On an Aisan for a 2F: Just received a carb with a busted vent tube - I can't find a place that sells Aisan vent tubes, but would love a link if that exists. If not:
1. It's broken off inside the carb upper, so it's impossible to grip the exterior of the tube - okay to use an EZ-out to pull the broken bit out?
2. Assuming I use a caliper to measure ID/OD, what's the right way to put them in? I've seen the Holley guys use a little loc-tite...
TIA!
1. It's broken off inside the carb upper, so it's impossible to grip the exterior of the tube - okay to use an EZ-out to pull the broken bit out?
2. Assuming I use a caliper to measure ID/OD, what's the right way to put them in? I've seen the Holley guys use a little loc-tite...
TIA!