i am thinking of going with sag steering in my 40 can I use a steering column from a 72' 55 that has a u joint on all ready or is it easier to just cut mine or is there an easy way to do sag like a custom column ???
CAN I USE THIS (1 Viewer)
- Thread starter FJ40Dude75
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
People have used GM columns before with good results, I just modified my factory unit, not too tough, probably easier than replacing the entire unit.
Once you go Saginaw you will never go back.
Once you go Saginaw you will never go back.
you need a 9/72 or later FJ55 donor for the column. The earlier will not work well and don't accept the steering wheel etc from the '75 FJ40.
also, a number of mini truck intermediate shafts will work.  
rill the safety spot welds out, slide (or cut and slide) to right length and re "plug weld". I would not use the stock FJ55 U joint bolt on deal.
...for FJ60 type conversions, the sweet intermediate is the 1985-1990 J60/2 shaft...
also, a number of mini truck intermediate shafts will work.  
rill the safety spot welds out, slide (or cut and slide) to right length and re "plug weld". I would not use the stock FJ55 U joint bolt on deal....for FJ60 type conversions, the sweet intermediate is the 1985-1990 J60/2 shaft...
