Can I hit the CDL button "On The Fly"?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 27, 2007
Threads
15
Messages
60
Any restrictions on speed as to when I can lock up the CD? Should I be stopped? In neutral, etc? Getting the button this week and was just curious how to NOT fry my drivetrain guts...
Thanks!
 
thanks, that's what I figured...
 
if you're moving, it would be function of the difference in slippage between front and rear.
low speed, no major slippage differential, probably fine.
 
Not saying Im right or wrong but I lock/unlock mine at 60+mph all the time.
 
Any time you think "shift on the fly" think of this 1 word, MESH.

If you DO NOT think the difference in rotation between the two (think) shafts and will allow the function of the switch?......DO NOT DO IT!

Buried or spinning tires in mud, sand, snow, ice? Then that is probably not the best time to try and shift. At that point either in a PT or a FT you CANNOT or SHOULD NOT allow for a difference in rotations and try to shift, it will not what?...........MESH.

Completely stop all 4 then proceed.


IF you think it will mesh then by all means go for it. (ie BEfore the obstacle)
 
Last edited:
From my understanding, the CDL does not force any two components together, it simply preloads a spring to lock the centre diff when everything else lines up, as with the axle lockers. I have pressed the button while turning and nothing happened (no dash lights/no locking) until I was going straight again and both shafts were at equal speeds. YMMV.

Pressing the CDL button is not like shifting a 2wd pickup into 4wd while spinning the back tires (bad grinding noises).
 
my 2000 4runner had a center diff lock switch that could be shifted on the fly up to 60mph. I notice many similarities between my 97 LC and the 2000 4Runner so I assume the CDL set up is comparable. That being said, I still don't hit my CDL over trail speeds and of course only when on a low traction surface.
 
I hit mine at whatever speed I'm going. Not while spinning tires, though.

Same here, no problem, unlock too 50-65mph several times. ABS will stay disabled until you can stop again though.
 
Have locked it up at 40+ mph if the conditions are really sloppy or on dirt road. Never had any issue. If there is plenty of slipping at the tires, lock the center diff.
 
When my 80 was constant 4wd I would use it on the move but usuall not faster than 80kmph. Not a good idea to be going much faster than that if traction is that bad you need to lock the centre diff.

Now that it is part time the CDL button is used to engage 4wd. Still no problems with engaging on the move. It gets used on the fly mostly when on the beach where 4wd is not needed all the time on the wet hard sand
 
Back
Top Bottom