I whipped out a few of these for some local club members. Going to throw this out and see if there is any interest from others who might be seeking something similar. Each of these sets cover the front and rear control arm bushings for the 80 series. These are made from 17-4 Stainless and heat treated to h900. These have a yield strength of 190,000 PSI so I would expect them to last a very very very long time....there is also the added bonus of the too cool for school bling bling heat treat gold. They are turned slightly less than the ID of the control arms to prevent binding and large enough to get a good push on the bushing sleeves.
I can custom turn a puck w/relief top or bottom for any size bushing you like. Also can do custom turning, threading, and boring.
$150 per set + $14 USPS shipping
I can also offer some limited manual machining service. I am equipped with a 16x36" capacity lathe and can accommodate a wide range of turning projects.
I can custom turn a puck w/relief top or bottom for any size bushing you like. Also can do custom turning, threading, and boring.
$150 per set + $14 USPS shipping
I can also offer some limited manual machining service. I am equipped with a 16x36" capacity lathe and can accommodate a wide range of turning projects.
Last edited: