Brake Pressure Warning Light Connector at Master (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 9, 2021
Threads
119
Messages
1,585
Location
Texas Coast
Good afternoon. On our 1070, I recently converted our rear drum brakes to discs and replaced the master cylinder with a 1" bore Aisin non ABS. The new master has an electrical port on the side for the brake pressure warning whereas the old stock MC that I removed had 2 spade type connectors on the bottom of the reservoirs. I'm looking to convert my wiring and need a plug connector to fit the new MC and would like to know if I can just splice into my existing wiring, or, if not, what is the best way to connect.
Thanks.


master cylinder warning light connector.jpg
 

Users who are viewing this thread

Back
Top Bottom